Nikon Professional Services Nikon Professional Services
Nikon Professional Services

Technical Solutions | D5 TIPS

Auto AF Fine-Tuning

The D5 can fine-tune autofocus automatically. The results can be used with all lenses of the same type.

Use only as required. AF fine-tuning should be performed at the focus distance at which the lens is normally used; fine-tuning performed at short focus distances may be less effective with distant subjects and vice versa.

1 Ready the camera.

Mount the camera on a tripod and aim the camera at a flat, high-contrast subject parallel to the camera focal plane. Note that auto AF fine-tuning works best at maximum aperture and may not function in dark surroundings.

2 Start live view.

Rotate the live view selector to and press the button.

3 Adjust focus settings.

Rotate the focus-mode selector to AF and use the AF-mode button and command dials to select the following:

  • Autofocus mode: AF‑S
  • AF-area mode: (wide) or (normal)

4 Select the center focus point.

Press the center of the multi selector to select the center focus point.

5 Focus.

Press the shutter-release button halfway to focus, then zoom in on the view through the lens to confirm that the subject is in focus.

6 Perform auto AF fine-tuning.

Press the AF-mode and movie-record buttons simultaneously and keep them pressed until the dialog shown in Step 7 is displayed (this should take slightly over two seconds).

AF-mode button

Movie-record button

7 Save the new value.

Highlight Yes and press to add the AF fine-tuning value for the current lens to the saved values list (CPU lenses only). Note that only one value can be stored for each type of lens.

8 Enable AF fine-tuning.

In the camera setup menu, select AF fine-tune > AF fine-tune (On/Off), then highlight On and press .